Formerly under the jurisdiction of Committee B02 on Nonferrous Metals and Alloys, this specification was withdrawn in April 2021. This standard is being withdrawn without replacement because the material, UNS N06110, is no longer being produced.

This specification covers annealed UNS N06110 alloy welded pipes for general corrosion applications. Each pipe should be made from the flat-rolled alloy by an automatic welding process without any filler metal additions. Either only the weld metal or both weld and base metals should be cold worked after welding and prior to final annealing. The piped should also be furnished and the oxide removed. Descaling is not necessary when bright annealing is used.

1.1 This specification covers welded UNS N061102 pipe in the annealed condition (temper) for general corrosion applications.

1.2 This specification covers pipe sizes in schedules shown in Table 1.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following precautionary caveat pertains only to the test method portion, Section 13, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety and health practices, and determine the applicability of regulatory limitations prior to use.