These test methods cover the determination of surface tension and interfacial tension of solutions of surface-active agents, as defined in Terminology D459.

Formerly under the jurisdiction of Committee D12 on Soaps and Other Detergents and the direct responsibility of Subcommittee D12.15 on Physical Testing, these test methods were withdrawn in January 2010 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

These test methods cover the determination of surface tension and interfacial tension of solutions of surface-active agents using a tensiometer. Method A covers aqueous solutions of surface-active agents, but is also applicable to non-aqueous solutions and mixed solvent solutions. Method B is applicable to two-phase solutions. More than one solute component may be present, including solute components that are not in themselves surface-active.

1.1 These test methods cover the determination of surface tension and interfacial tension of solutions of surface-active agents, as defined in Terminology D459. Two methods are covered as follows:

Method ASurface Tension.

Method BInterfacial Tension.

1.2 Method A is written primarily to cover aqueous solutions of surface-active agents, but is also applicable to nonaqueous solutions and mixed solvent solutions.

1.3 Method B is applicable to two-phase solutions. More than one solute component may be present, including solute components that are not in themselves surface-active.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Material Safety Data Sheets are available for reagents and materials. Review them for hazards prior to usage.