1.1 These test methods cover procedures for sampling, examination, physical testing, and analyses of asphalt-containing materials used in roofing and waterproofing. These materials include but are not limited to roll roofing, cap sheets, and shingles. Any of these materials are allowed to be partially or fully coated, surfaced, or laminated, or a combination thereof.
1.2 The test methods and procedures in this standard appear in the following order:
SectionContent5Types of Roofing6Sampling7Mass and Area Determination8Selection of Representative Specimens9Moisture10Pliability11Mass Loss and Behavior on Heating12Tear Strength13Fastener Pull-Through Resistance14Preparation and Selection of Small Test Specimens for Analyses15Analysis of Glass Felt Products16Analysis of Roofing Products with Organic Felts17Ash of Desaturated Felt18Calculation19Adjusting Back Coating Fine Mineral Matter and Back Surfacing20Report21Precision and Bias1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.