Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM D2447-03

Отменен
Standard Specification for Polyethylene (PE) Plastic Pipe, Schedules 40 and 80, Based on Outside Diameter (Withdrawn 2010) — 8 стр.
Причина отмены

This specification covers polyethylene (PE) pipe that is outside diameter controlled, made in Schedule 40 and 80 sizes for use with socket-type fittings and butt fittings joined by heat fusion, and pressure-rated for water (see appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.

This standard is being withdrawn with no replacement because queries to industry have not identified manufacturers that are producing pipe to this standard. Formerly under the jurisdiction of Committee F17 on Plastic Piping Systems, this specification was withdrawn in August 2010.

Реферат

This specification covers the physical and dimensional requirements for polyethylene (PE) pipes that is outside diameter controlled, made in Schedule 40 and 80 sizes, for use with socket-type fittings and butt fittings joined by heat fusion, and pressure-rated for water. Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and corresponding test methods for materials, workmanship, dimensions (outside diameter, wall thickness, and thickness of outer layer), density, sustained pressure, burst pressure, and environmental stress cracking.

Область применения

1.1 This specification covers polyethylene (PE) pipe that is outside diameter controlled, made in Schedule 40 and 80 sizes for use with socket-type fittings and butt fittings joined by heat fusion, and pressure-rated for water (see appendix). Included are criteria for classifying PE plastic pipe materials and PE plastic pipe, a system of nomenclature for PE plastic pipe, and requirements and test methods for materials, workmanship, dimensions, sustained pressure, burst pressure, and environmental stress cracking. Requirements for marking are also given.

1.2 The values stated in inch-pound units are to regarded as the standard. The values given in parentheses are for information only.

1.3 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ICS
23.040.20 Plastics pipes / Пластмассовые трубы
Сборник ASTM
08.04 Plastic Piping Systems (I): D1598 – F2735 / Пластиковые трубопроводные системы (I): D1598 – F2735
Тематика
Plastic Pipe