This specification covered mineral-colloid-stabilized, emulsified coal-tar pitch suitable for use as a weather-protective and aliphatic-solvent resistant coating over bituminous pavements of airports, parking areas, and driveways.

Formerly under the jurisdiction of Committee D08 on Roofing and Waterproofing, this specification was withdrawn in July 2013 in accordance with section 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

This specification describes the test methods for and physical requirements of mineral-colloid-stabilized, emulsified coal-tar pitch suitable for use as a weather-protective and aliphatic-solvent resistant coating over bituminous pavements of airports, parking areas, and driveways. The emulsion shall be made using tars having viscosities of RT-11 or higher, and the mineral filler (mineral colloids) shall consist of finely ground clay, silica, or other inert inorganic materials. And when specified, the emulsion shall be fortified with antifreeze. The properties for which coal-tar pitches shall be appropriately tested on and accordingly adhere to are: wet film continuity; freezing resistance; density; volatile matter content; residue by evaporation; volatilization resistance and residue weight loss; solubility of residue in CS₂; ash content of residue; flammability; drying time and firm set; heat resistance; resistance to kerosene and water; and impact resistance before and after accelerated weathering.

1.1 This specification covers mineral-colloid-stabilized, emulsified coal-tar pitch suitable for use as a weather-protective and aliphatic-solvent resistant coating over bituminous pavements of airports, parking areas, and driveways.

1.2 The values stated in SI (metric) units are to be regarded as the standard.

The following precautionary caveat pertains only to the test method portion, Section , of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.