This test method describes a procedure for the determination of grease life and torque in small bearings. Although this test method is not the equivalent of a long-time ASTM 100HARBOR WEST CONSHOHOCKEN, PAfield-service test, it is intended to predict the relative grease life at high temperature in a reasonable period of testing time. In addition, this test method measures the running torque at both low (1 r/min) and high (12 000 r/min) speeds.
Formerly under the jurisdiction of Committee F34 on Rolling Element Bearings, this test method was withdrawn in July 2009 due to the unavailability of test apparatus. There is no replacement of this test method.
Значение и использованиеThis test method is a screening test to differentiate among the expected life of greases in ball bearings running at high temperatures. If torque is a factor in selection of a grease, the test method provides for measurements at both low (1 r/min) and high (12 000 r/min) speeds.
Область применения1.1 This test method describes a procedure for the determination of grease life and torque in small bearings. Although this test method is not the equivalent of a long-time field-service test, it is intended to predict the relative grease life at high temperature in a reasonable period of testing time. In addition, this test method measures the running torque at both low (1 r/min) and high (12 000 r/min) speeds.
1.2 Except for torque, which is measured in gcm, the values stated in inch-pound units are to be regarded as the standard in this test method. The SI values given in parenthesis are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.