Причина отмены This test method covers the determination of alpha-particle-emitting isotopes of plutonium concentrations over 0.01 Bq/L (0.3 pCi/L) in water by means of chemical separations and alpha pulse-height analysis (alpha-particle spectrometry). Due to overlapping alpha-particle energies, this method cannot distinguish ²³⁹Pu from ²⁴⁰Pu. Plutonium is chemically separated from a 1-L water sample by coprecipitation with ferric hydroxide, anion exchange and electrodeposition. The test method applies to soluble plutonium and to suspended particulate matter containing plutonium. In the latter situation, an acid dissolution step is required to assure that all of the plutonium dissolves.

Formerly under the jurisdiction of Committee D19 on Water, this test method was withdrawn in February 2024 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Значение и использование

5.1 This test method was developed to measure plutonium in environmental waters or waters released to the environment and to determine whether or not the plutonium concentration exceeds the maximum amount allowable by regulatory statutes.

Область применения

1.1 This test method covers the determination of alpha-particle-emitting isotopes of plutonium concentrations over 0.01 Bq/L (0.3 pCi/L) in water by means of chemical separations and alpha pulse-height analysis (alpha-particle spectrometry). Due to overlapping alpha-particle energies, this method cannot distinguish ²³⁹Pu from ²⁴⁰Pu. Plutonium is chemically separated from a 1-L water sample by coprecipitation with ferric hydroxide, anion exchange and electrodeposition. The test method applies to soluble plutonium and to suspended particulate matter containing plutonium. In the latter situation, an acid dissolution step is required to assure that all of the plutonium dissolves.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 9.