This test method covers the creep behavior of intact cylindrical rock core specimens' in triaxial compression. It specifies the apparatus, instrumentation, and procedures for determining the strain as a function of time under sustained load.

Formerly under the jurisdiction of Committee D18 on Soil and Rock, this test method was discontinued in May 2005 and replaced by D 7070, Test Method for Creep of Rock Core Under Constant Stress and Temperature.

For referenced ASTM standards, visit the ASTM website, www.astm.org, or contact ASTM Customer Service at service@astm.org. For Annual Book of ASTM Standards volume information, refer to the standard's Document Summary page on the ASTM website.

1.1 This test method covers the creep behavior of intact cylindrical rock core specimens' in triaxial compression. It specifies the apparatus, instrumentation, and procedures for determining the strain as a function of time under sustained load.

1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026.

1.2.1 The method used to specifiy how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design or other uses, or both. How one applies the results obtained using this standard is beyond its scope.

1.3 The values stated in SI units are to be regarded as the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7.