4.1 This test method is used to determine the grading of materials used as surfacing. The results are used to determine compliance of the particle size distribution with applicable specification requirements.

1.1 This test method covers the determination of the particle size distribution of surfacing material, other than mineral granules, such as sand, mica, talc, or other powdered or flaky mineral particles, used on both sides of “smooth” roll roofing and on the reverse side of asphalt shingles and mineral-surfaced roll roofing.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.