Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM D4565-15

Заменен
Standard Test Methods for Physical and Environmental Performance Properties of <brk/>Insulations and Jackets for Telecommunications Wire and Cable — 19 стр.
Значение и использование

5.1 Dimensional measurements, properly interpreted, provide information with regard to the conductors, insulation, or jacket. The dimensional measurements provide data for research and development, engineering design, quality control, and acceptance or rejection under specifications.

Область применения

1.1 These test methods cover procedures for the physical testing of thermoplastic insulations and jackets used on telecommunications wire and cable and the testing of physical characteristics and environmental performance properties of completed products. To determine the procedure to be used on the particular insulation or jacket or on the completed wire or cable, make reference to the specification for that product.

1.2 The test methods appear in the following sections of this standard:

Procedure

Sections

Dimensional measurements of insulations, jackets,
miscellaneous cable components, and of completed cable


4 – 9

 Cross-sectional areas

9

 Diameters

6

 Eccentricity

8

 Thickness

7

Physical and environmental tests of insulation and jackets

10 – 25

 Aging test (jackets only)

24

 Cold bend (insulation only)

16

 Environmental stress crack (polyolefin jackets only)

21

 Heat distortion (jackets only)

22

 Heat shock (jackets only)

23

 Insulation adhesion

19

 Insulation and jacket shrinkback (oven test)

14

 Insulation compression

20

 Insulation shrinkback (solder test)

15

 Melt flow rate change—polyolefin materials

12

 Oil immersion test (jackets only)

25

 Oxygen induction time (polyolefin insulation only)

17

 Oxygen induction time (cable filling compound only)

18

 Tensile and elongation tests

13

Physical and environmental tests of insulations and jackets of    completed wire and cable


26 – 42

 Cable Torsion Test

38

 Compound flow test (filled core wire and cable only)

42

 Corrugation extensibility test

36

 Cable impact test

33

 Jacket bonding tests

29

Procedure

Sections

 Jacket notch test

32

 Jacket peel or pull

28

 Jacket slip strength test

30

 Pressure test (air core wire and cable only)

40

 Sheath adherance test

31

 Water penetration test (filled core wire and cable only)

41

 Wire and cable bending test

34

 Wire breaking strength

37

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard, except where only SI units are given.

1.4  This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific caution statement see 19.1.

ICS
29.035.01 Insulating materials in general / Изоляционные материалы в целом
Сборник ASTM
10.02 Electrical Insulation (II): D2519–latest / Электрическая изоляция (II): с D2518 и далее
Тематика
Electrical Insulating Materials