This specification covered reinforced thermosetting plastic poles used for outdoor lighting. Such poles may be applicable to electric power and telecommunication distribution installations.

Formerly under the jurisdiction of Committee D20 on Plastics, this specification was withdrawn in February 2010 in accordance with subsection 10.5.3.1 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

This specification covers reinforced thermosetting plastic poles used for outdoor lighting. Such poles may be applicable to electric power and telecommunication distribution installations. The poles are classified as class 1, which uses standard pole and class 2, which uses stiff pole. The shaft shall be a composite of thermosetting resin, reinforced with glass or other fibers, and its exterior surface may have a textured pattern or a smooth finish. Materials shall be tested and the individual classes shall conform to the requirements of direct burial poles, base-mounted poles, poles designed for post-top luminaries, poles designed for support-arm application; performance requirements such as bending moment, pole-top deflection, standard pole, stiff pole, torsional moment, flexural fatigue, burn rate, conductivity, and breakaway poles. The workmanship, finish, appearance, and wiring and access are also detailed.

1.1 This specification covers reinforced thermosetting plastic poles used for outdoor lighting. Such poles may be applicable to electric power and telecommunication distribution installations.

1.2 The design parameters of the poles shall be agreed upon by the purchaser and supplier and should take into consideration the anticipated service conditions of installation and transportation of the product.

1.3 This specification includes poles with above-ground or standard mounting height of 10 ft (3.05 m) through 50 ft (15.24 m). Two classes of poles are covered, one of standard design, the other of stiff design.

1.4 The values stated in inch-pound units are to be regarded as standard. Equivalent SI units are indicated in parentheses.

1.5 The following precautionary caveat pertains only to the test methods portion of this specification, Section 10: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.