Значение и использование

This test method is used to determine the ability of an engine crankcase oil to control wear that can develop in the field under low to moderate engine speeds and heavy engine loads. Side-by-side comparisons of two or more oils in delivery van fleets were used to demonstrate the field performance of various oils. The specific operating conditions of this test method were developed to provide correlation with the field performance of these oils.

This test method, along with other test methods, defines the minimum performance level of the Category API CG-4 for heavy duty diesel engine lubricants. Passing limits for this category are included in Specification D 4485.

The design of the engine used in this test method is not representative of all modern diesel engines. This factor, along with the specific operating conditions used to accelerate wear, shall be considered when extrapolating test results.

Область применения

1.1 This engine lubricant test method is commonly referred to as the Roller Follower Wear Test. Its primary result, roller follower shaft wear in the hydraulic valve lifter assembly, has been correlated with vehicles used in stop-and-go delivery service prior to 1993. It is one of the test methods required to evaluate lubricants intended to satisfy the API CG-4 performance category. This test has also been referred to as the 6.2 L Test.

1.2 The values of units used in this test method are stated in either inch-pound units or SI units and are to be regarded separately as the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 Table of Contents:

Section Scope1 Referenced Documents2 Terminology3 Summary of Test Method4 Significance and Use5 Reagents7 Guidelines on Substitution7.1 Apparatus6 Preparation of Apparatus8 New Engine Preparation8.1 Installation of Auxiliary Systems and
Miscellaneous Components8.2 Test Procedure9 Description of Test Segments and Organization
of Test Procedure Sections9.1 Engine Parts Replacement9.2 Engine Starting Procedure9.3 Normal Engine Shutdown Procedure9.4 Emergency Shutdown Procedure9.5 Unscheduled Shutdown and Downtime9.6 New Engine Break-In9.7 Pretest Procedure9.8 Fifty-Hour Steady State Test9.9 Periodic Measurements9.10 Oil Sampling and Oil Addition Procedures9.11 End of Test (EOT) Procedure9.12 Calculation and Interpretation of Test Results10 Environment of Parts Measurement Area10.1 Roller Follower Shaft Wear Measurements10.2 Oil Analysis10.3 Assessment of Test Validity10.4 Final Test Report11 Reporting Calibration Test Results11.1 Report Forms11.2 Interim Non-Valid Calibration Test Summary11.3 Severity Adjustments11.4 Precision and Bias13 Precision13.1 Precision Estimate13.2 Bias13.3 Keywords14 ANNEXES Guidelines for Test Part Substitution or ModificationAnnex A1 Guidelines for Units and Specification FormatsAnnex A2 Detailed Specifications of ApparatusAnnex A3 CalibrationAnnex A4 Final Report FormsAnnex A5 IllustrationsAnnex A6 Kinematic Viscosity at 100°C Procedure for the
Roller Follower Wear TestAnnex A7 Enhanced Thermal Gravimetric Analysis (TGA)
Procedure for Soot MeasurementAnnex A8 Sources of Materials and InformationAnnex A9 APPENDIXES PC-9 Reference Diesel Fuel PropertiesAppendix X1 Diagnostic Data ReviewAppendix X2