3.1 These tests are useful in sampling and testing solvent bearing bituminous compounds to establish uniformity of shipments.

1.1 These test methods cover procedures for sampling and testing solvent bearing bituminous compounds for use in roofing and waterproofing.

1.2 The test methods appear in the following order:

Section

Sampling

4

Uniformity

5

Weight per gallon

6

Nonvolatile content

7

Solubility

8

Ash content

9

Water content

10

Consistency

11

Behavior at 60 °C [140 °F]

12

Pliability at –0 °C [32 °F]

13

Aluminum content

14

Reflectance of aluminum roof coatings

15

Strength of laps of rolled roofing adhered with roof adhesive

16

Adhesion to damp, wet, or underwater surfaces

17

Mineral stabilizers and bitumen

18

Mineral matter

19

Volatile organic content

20

1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.