Formerly under the jurisdiction of Committee D13 on Textiles, this practice was withdrawn in January 2017 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

This practice provides a common format that allows a computer design system to generate data that an output device can accurately reproduce independent of the hardware manufacturer.

1.1 This practice specifies a data format for numerically-controlled cutting machines for fabric.

1.2 This standard uses a subset of the defined instruction set defined in ANSI/EIA-274-D in addition to the codes defined by this practice.

1.3 This practice does not support curve interpolation or definitions. All curves are represented by discrete vectors (stroked) and are dependent on the resolution of the CAD software.

1.4 This practice requires that all coordinates are absolute, not relative.

1.5 This practice only supports positive coordinates that are measured from a single X-Y origin point with coordinates (0,0). The origin point is specified as the lower left corner of the cut file.

1.6 This practice intends to transfer a static image with no provision for editing.

1.7 This practice imposes no limits on the width or length of the cut data. Physical limitations imposed by the hardware and their effects on the output are the responsibility of the hardware manufacturer.

1.8 This practice does not support bite commands or any methods that insert multiple origin points or floating coordinate systems.

1.9 This practice does not support notch tools.

1.10 This practice does not support pattern matching.

1.11 This practice limits the cut file to contain a single block of data demarked by a compatible header and terminator. Multiple blocks of data in a single file are not allowed.

1.12 Any commands found in the cut file that are not defined by this standard shall be ignored.

1.13 The intended application of this practice is limited to the class of output devices found in the sewn product industries that produce apparel, textiles, upholstery, and others that use soft or semi-rigid materials.

1.14 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.