Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM D7207-05

Отменен
Standard Test Method for Determination of Unvegetated Rolled Erosion Control Product (RECP) Ability to Protect Sand from Hydraulically-Induced Shear Stresses under Bench-Scale Conditions (Withdrawn 2014) — 6 стр.
Причина отмены

This index test method establishes the guidelines, requirements and procedures for evaluating the ability of unvegetated Rolled Erosion Control Products (RECPs) to protect soil (sand) from hydraulically induced shear stress in a bench-scale apparatus.

Formerly under the jurisdiction of Committee D18 on Soil and Rock, this test method was withdrawn in February 2014 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Значение и использование

This index test method indicates an unvegetated RECPs ability to reduce soil erosion caused by shear stress induced by moving water under bench-scale conditions. Only tangential shear is measured in this method. Radial and uplift forces generated by the circular motion of the water are not measured.

This test method is bench-scale and therefore, appropriate as an index test for general soil/product composite behavior under hydraulic shear conditions, and for product quality assurance/conformance testing. The results of this test shall not be interpreted as indicative of field performance.

Область применения

1.1 This index test method establishes the guidelines, requirements and procedures for evaluating the ability of unvegetated Rolled Erosion Control Products (RECPs) to protect soil (sand) from hydraulically induced shear stress in a bench-scale apparatus.

1.2 This index test method utilizes bench-scale testing procedures and shall not be interpreted as indicative of field performance.

1.3 This index test is not intended to replace full-scale simulation or field testing in acquisition of performance values that are required in the design of erosion control measures utilizing unvegetated RECPs.

1.4 The values stated in SI units are to be regarded as standard. The inch-pound values given in parentheses are provided for information purposes only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

ICS
13.080.05 Examination of soils in general / Анализ грунта в целом
Сборник ASTM
04.09 Soil and Rock (II): D5878 – latest / Грунт и Горные породы (II): с D5878 и далее
Тематика
Geotechnical Engineering