5.1 For proper bonding of overlays and coatings, it is important that a concrete surface have the correct surface profile. This test method allows one to obtain a permanent replica of the concrete surface, which can then be compared to visual profile standards, or evaluated quantitatively for profile depth. The permanent replica may also prove useful in resolving future disputes.

FIG. 1 Plastic Profiler with Replica Putty on Concrete

1.1 This test method is suitable for both field and laboratory use to obtain a permanent record of concrete surface profile using replica putty and to determine the depth of that surface profile.

Note 1: The procedure in this standard was developed for concrete substrates but may be appropriate for other rigid substrates.

1.2 A profile can be imparted to concrete by various methods such as blast cleaning and acid etching. The depth of the surface profile has been shown to be a factor in coating adhesion and performance.

1.3 The International Concrete Repair Institute (ICRI) provides a means of visually judging a concrete surface by use of ten different visual comparators called Concrete Surface Profiles (CSP). This standard compliments the use of these visual comparators.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.