Причина отмены These test methods cover procedures for the testing of resin-coated glass fabrics and glass fabric tapes to be used as electrical insulation.

Formerly under the jurisdiction of Committee D09 on Electrical and Electronic Insulating Materials, these test methods were withdrawn in March 2020. This standard is being withdrawn without replacement because it is no longer being maintained.

Значение и использование

The electrical properties of resin-coated glass fabrics are affected by their temperature and moisture content. For this reason it is necessary to control these properties for a specified time immediately prior to testing in order to attain reasonably good reproducibility of test values. The time of exposure to the conditioning atmosphere must be long enough to permit the test specimen to reach a relatively stable value. Usually the moisture content of these materials has little effect on the mechanical properties.

Область применения

1.1 These test methods cover procedures for the testing of resin-coated glass fabrics and glass fabric tapes (Note 1) to be used as electrical insulation.

Note 1—Methods of testing varnished cloths and tapes are given in Methods D295.

1.2 The warp threads in fabrics are the threads that are parallel with the length dimension as manufactured.

1.3 The procedures appear as follows:

Procedure
SectionASTM Test
Method Reference Breaking Strength22-28D828 Conditioning 6-8... Dielectric Breakdown Voltage and Di-
electric Strength29-38D149, D295 Dissipation Factor and Relative Permit-
tivity52-60D150, E104, D5032 Effect of Elevated Temperature39-45D1830 Resistance to Oil46-51D3487 Sampling 3-5... Thermal Endurance68 D1830 Thickness16-21D374 Thread Count12-15... Weight 9-11... Weight Loss at Elevated Temperature61-67 D5423

1.4 The values stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific warning statement are given in 35.1.1 and 58.1.