5.1 In the primary metallurgical processes used by the mineral processing industry for gold bearing ores, gold is extracted with alkaline cyanide solutions and adsorbed onto activated carbon for recovery of the metal. Metallurgical accounting, process control, and ore evaluation procedures for this type of mineral processing plant depend on accurate, precise, and prompt measurements of gold concentrations in the activated carbon.

5.2 This test method for gold in activated carbon is intended primarily as a referee method to test such materials for metal content. It is assumed that those who use these procedures will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices must be followed, such as those described in Guide E882.

1.1 This test method covers the determination of gold in activated carbon by fire assay collection and gravimetric measurement. It covers the range of 15 μg/g to 5000 μg/g gold.

1.2 Units—The values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. For specific hazards statements, see Section 9, 11.2.3 – 11.2.5, and 11.3.4.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.