This specification covers minimum photometric requirements for newly applied photoluminescent (phosphorescent) safety materials used to provide supplemental markings of escape routes, emergency equipment, and obstructions along the escape route. This specification does not cover potentially diminished performance due to wear and tear and aging. The photoluminescent safety materials shall be tested and shall conform to optical requirements and to the specified values of on-site luminance, activation, and marking width.

1.1 This specification covers minimum performance requirements for newly applied photoluminescent (phosphorescent) safety materials used to provide supplemental markings of escape routes, emergency equipment, and obstructions along the escape route. (See Test Method E2073 and Guide E2030).

1.2 This specification establishes minimum luminance values for photoluminescent (phosphorescent) markings.

1.3 This specification applies to all types of photoluminescent (phosphorescent) markings, including but not limited to plastics, coatings, ceramics, films, etc.

1.4 This specification does not cover potentially diminished performance due to wear and tear and aging.

1.5 This specification applies only to photoluminescent (phosphorescent) markings emitting the majority of spectral energy within the 515 to 535 nanometer range.

1.6 When reference is made regarding photoluminescence in the text of this standard, it implies phosphorescence.

1.7 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.