Причина отмены This practice covers the determination of the Scleroscope1 hardness of metallic materials (Part A), the verification of Scleroscope hardness instruments (Part B), and the calibration of standardized hardness test blocks (Part C).

Formerly under the jurisdiction of Committee E28 on Mechanical Testing, this practice was withdrawn in January 2017 in accordance with section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

Реферат

This practice establishes the standard procedures for the determination of the Scleroscope hardness of metallic materials, the verification of Scleroscope hardness instruments by a standardized test block method, and alternatively, the calibration of standardized hardness test blocks used for the verification of Scleroscope hardness instruments.

Область применения

1.1 This practice covers the determination of the Scleroscope hardness of metallic materials (Part A), the verification of Scleroscope hardness instruments (Part B), and the calibration of standardized hardness test blocks (Part C).

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.