This specification covers the requirements for manually fed, motor-driven vertically oscillating arm type, automatically controlled, commercial pot, pan, and utensil washing machine (also referred to as "the washer"). The washer is of one rack capacity (Type I) and is available in either Style A (one door/front loading) or Style B (three door/pass-through with front load door). Heat shall be provided to the washer through steam (Style 1) by injection (Class A) or heat exchange coil (Class B) or through electric means (Style 2). The washer and its components shall be manufactured free of defects. Piping and fittings shall be manufactured from corrosion-resisting material or heat-resisting plastic material. Valves, spray assemblies, and overflow drain shall be manufactured from corrosion-resisting materials. Tank and housing shall be constructed of corrosion-resistant steel. Scrap trays (strainers), access door/s, and legs shall be constructed of corrosion-resistant steel or other corrosion-resisting material. The pump motor shall be mounted on the tank or rigid steel base, with the pump casing being of cast iron or corrosion-resisting material. When specified, a final rinse booster heater and/or detergent feeder may be provided. The washer shall be operated at ambient room temperature. Tests for performance standards and operational compliance as well as for noise level, leakage, energy, and productivity requirements shall be performed and shall conform to the requirements specified.

1.1 This specification covers manually fed, motor-driven vertically oscillating arm type, automatically controlled, commercial pot, pan, and utensil washing machines, hereinafter referred to as “the washer.”

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following precautionary statement pertains only to the test methods portion, Section 9 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.