Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM F3139-15(2023)

Действует
Standard Test Method for Analysis of Tin-Based Solder Alloys for Minor and Trace Elements Using Inductively Coupled Plasma Atomic Emission Spectrometry — 8 стр.
Значение и использование

4.1 Tin-based solder alloys are commonly used to manufacture electrical and electronic goods. The elements lead, cadmium, mercury, antimony and bismuth are often declarable substances in solder materials. This test method provides a means of determining the listed declarable substances, as well as other minor and trace constituents, in tin-based solder alloys.

4.2 Two methods of dissolving tin-based solder alloys are given in this standard. The first method uses open-vessel hydrofluoric and nitric acid room temperature digestions; the second method employs closed-vessel nitric and hydrofluoric acid microwave digestions, both for use only with ICP-AES instruments equipped with a hydrofluoric acid resistant sample introduction system.

4.3 The method of preparing calibration solutions uses 1000 mg/kg single element reference material solutions, and uses matching concentrated acids for both the calibration solutions and the sample solutions.

4.4 This test method is intended for use by laboratories experienced with the set-up, calibration and analysis of samples using ICP-AES.

Область применения

1.1 This test method covers procedures for the analysis of tin-based solder alloys for minor and trace elements using inductively-coupled plasma atomic emission spectrometry (ICP-AES) instrumentation.

1.2 These test procedures were validated for the analytes and mass fractions listed below.

Element

Validated Mass Fraction
Range, mg/kg

 

 

Lead

115 to 965

Cadmium

25 to 60

Mercury

5 to 530

Antimony

85 to 1330

Bismuth

80 to 210

Arsenic

95 to 360

Silver

4000 to 42100

Cobalt

0.5 to 60

Iron

15 to 115

Chromium

0.5 to 1.5

Copper

3000 to 30600

Indium

25 to 115

Nickel

5 to 150

Phosphorus

10 to 110

Selenium

1 to 30

Zinc

2 to 160

Aluminum

1 to 3

1.3 The procedures appear in the following order:

Procedure

Section

Internal Standardization

8

Calibration Solution Preparations

9

Preparation of Sample and Validation Solutions

10

Calibration

11

Analysis Procedure

12

1.4 The values stated in SI units are to be regarded as the standard. Any other values are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

ICS
25.220.40 Metallic. Including electrolytic depositions, cathodic coatings, autocatalytic coatings, etc. / Металлические покрытия. Включая электролитическое осаждение, катодные покрытия и т.д.
Сборник ASTM
10.04 Electronics; Declarable Substances in Materials; 3D Imaging Systems; Additive Manufacturing Technologies / Электроника; Декларируемые вещества в материалах; Системы 3D-визуализации; Аддитивные технологии производства