This specification supplies the general characteristics and requirements, and interface details of propeller-type, fixed-tunnel thruster units that are permanently installed in marine vessels or structures. Thrusters manufactured in accordance with this specification shall be identified by the following types and grades: Type I—fixed pitch; and Type II—controllable pitch; Grade 1—intermittent duty for docking and navigation; and Grade 2—continuous duty for stationkeeping or dynamic positioning. The thrusters shall meet the design, manufacturing, dimensional, and workmanship requirements specified herein.

1.1 This specification supplies general characteristics and interface details of propeller type, fixed-tunnel thruster units permanently installed in marine vessels or structures.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

Note 1: This specification supplies only general design, interface, and purchase information and does not include requirements for use, thruster controls, or associated equipment. The purchaser of the thruster equipment specified herein is cautioned that he must properly correlate the operating requirements with the thruster specified.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.