Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ASTM F991M-04(2008)

Заменен
Standard Specification for Docking/Drain Plug and Boss Assemblies [Metric] — 3 стр.
Реферат

This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies. Assemblies are intended for installation in shell, rudder, and tank bottom plate. Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking. Docking plugs and bosses shall be classified as follows: type I - docking plug and bosses for plating from 8 to 15 mm, and type II - docking plug and bosses for plating greater than 15 to 38 mm. The procedure for installing docking/drain plug and boss assemblies are presented.

Область применения

1.1 This specification provides design, construction, and purchasing criteria for docking/drain plug and boss assemblies.

1.2 Assemblies are intended for installation in shell, rudder, and tank bottom plate from 8 through 38 mm.

1.3 Assemblies shall be installed at the lowest point of a tank or rudder for draining during dry docking.

1.4 The values stated in SI units are to be regarded as the standard.

ICS
23.020.10 Stationary containers and tanks / Стационарные контейнеры и баки
Сборник ASTM
01.07 Ships and Marine Technology (I): F670 – F1511 / Судоходные и Морские Технологии (I): F670 – F1511
Тематика
Steel--Structural, Tubes, Plate, Coated