Formerly under the jurisdiction of Committee F05 on Business Imaging Products, this practice was withdrawn in June 2017 in accordance with Section 10.6.3 of the Regulations Governing ASTM Technical Committees, which requires that standards shall be updated by the end of the eighth year since the last approval date.

This practice may be used to evaluate the performance of different toners in a common machine. It can also be used to evaluate the economics of toner usage when making machine-to-machine comparisons.

The practice provides only a point estimate that is subject to a significant number of variables that are not easily measured. As with all dry developers, two-component developer systems are not 100 % efficient. Some toner is lost to the surroundings (inside or outside the copier). This loss is also dependent on copier adjustments and may be significant enough to affect the total number of copies capable of being produced by a specific amount of toner. Anyone making a decision based on the results of this practice should carefully consider the accuracy of the results and other pertinent data.

Actual use of the copier in normal operating conditions will most likely result in toner usage values different from those generated in this practice.

1.1 This practice describes a procedure for estimating the number of copies that can be produced for a given unit of toner in a copier using dry two-component developer.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 9 for specific precautionary statements.