BS ISO 4427-5. Plastics piping systems for water supply, and for drainage and sewerage under pressure. Polyethylene (PE). Part 5. Fitness for purpose of the system— 17 стр.
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 4: Preparation of assemblies— 12 стр.
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 2: Preparation of pipe test pieces— 10 стр.
Plastics pipes and fittings. Decohesion test of polyethylene (PE) saddle fusion joints. Evaluation of ductility of fusion joint interface by tear test— 20 стр.
Plastics pipes and fittings - Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm— 10 стр.
Plastics piping systems -- Polyethylene (PE) pipes and fittings for water supply -- Part 1: General -- Amendment 1: Melt mass-flow rate (MFR) for PE 80 and PE 100— 8 стр.
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure – Part 1: General method— 16 стр.