Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure – Part 1: General method— 16 стр.
Thermoplastics pipes, fittings and assemblies for the conveyance of fluids -- Determination of the resistance to internal pressure -- Part 2: Preparation of pipe test pieces— 10 стр.
Plastics -- Symbols and abbreviated terms -- Part 1: Basic polymers and their special characteristics -- Amendment 1: New symbol ST for syndiotactic— 6 стр.
Plastics piping and ducting systems -- Determination of the long-term hydrostatic strength of thermoplastics materials in pipe form by extrapolation— 36 стр.
Plastics pipes and fittings - Peel decohesion test for polyethylene (PE) electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm— 10 стр.
Thermoplastics pipes for the conveyance of fluids -- Determination of resistance to rapid crack propagation (RCP) -- Small-scale steady-state test (S4 test)— 20 стр.
Plastics piping systems for buried and above-ground pressure systems for water for general purposes, drainage and sewerage. Polyethylene (PE). General— 22 стр.
Plastics - Determination of the melt mass-flow rate (MFR) and melt volume-flow rate (MVR) of thermoplastics - Part 1: Standard method (ISO 1133-1:2011); German version EN ISO 1133-1:2011— 33 стр.
