Каталог стандартов

+7 (495) 223-46-76 +7 (812) 309-78-59
inform@normdocs.ru

ÖNORM EN ISO 11125-3:1997-10

Заменен
Preparation of steel substrates before application of paints and related products - Test methods for metallic blast-cleaning abrasives - Part 3: Determination of hardness
This is one of a number of Parts of ISO 11125 dealing
with the sampling and testing of metallic abrasives for
blast-cleaning.
The types of metallic abrasive and requirements
on each are contained in the various Parts of
ISO 11124.
The ISO 11124 and ISO 11125 series have been
drafted as a coherent set of International Standards
on metallic blast-cleaning abrasives. Information on all
Parts of both series is given in annex A.
This patt of ISO 11125 specifies a test method for the
determination of the Vickers hardness of metallic
blast-cleaning abrasives.
This method is not recommended for the testing of
particle sizes below 0,3 mm.
NOTE 1 Accurate testing of particles below 0,3 mm
(grades S040/G050) is extremely difficult.
2 Normative references
The following Standards contain provisions which,
through reference in this text, constitute provisions
of this part of ISO 11125. At the time of publication,
the editions indicated were valid. All Standards are
subject to revision, and Parties to agreements based
on this part of ISO 11125 are encouraged to investigate
the possibility of applying the most recent editions
of the Standards indicated below. Members of
IEC and ISO maintain registers of currently valid
International Standards.
ISO 6507.2:1983, Metallic materials - Hardness test
- Vickers test - Part 2: HV 0,2 to less than H V 5.
ISO 11125-1:1993, Preparation of steel Substrates
be fore applica tion of paints and related products -
Test methods for metallic blast-cleaning abrasives -
Part 1: Sampling.
Dieser Teil der Norm legt ein Prüfverfahren zur Bestimmung der Vickershärte von metallischen Strahlmitteln fest. Dieses Verfahren wird nicht für Korngrößen unter 0,3 mm empfohlen. Die verschiedenen Arten metallischer Strahlmittel und Anforderungen an diese sind in den verschiedenen Teilen von ISO 11124 enthalten. Die Normenreihen ISO 11124 und ISO 11125 wurden als zusammengehöriger Satz von Internationalen Normen über metallische Strahlmittel ausgearbeitet.
ICS
25.220.10 Surface. Including surface preparation for painting, cleaning, scouring, blasting, etc. / Подготовка поверхности. Включая подготовку поверхности под окраску, зачистку, шабрение, струйную очистку и т.д.