This part of IEC 62677 is applicable to heat shrinkable low voltage moulded shapes in a range
of configurations suitable for insulation, environmental sealing, mechanical protection, strain
relief for power cable terminations, joints and stop ends. These moulded shapes have been
found suitable for use for temperatures between –40 °C and 100 °C.
The moulded shapes can be supplied with a pre-coated adhesive. A guide to adhesive
compatibility and temperature performance is given in Annex A. The manufacturers/suppliers
can be consulted for options.
The material is available in two types:
Type A – Flame retardant
Type B – Not flame retardant
Materials which conform to this document meet established levels of performance. However,
the selection of a material by a user for a specific application will be based on the actual
requirements necessary for adequate performance in that application and will not be based on
this document alone.
The tests specified are designed to control the quality of the moulded shapes but it is
recognized that they are designed to be used in low and medium voltage cable accessories
and, as such, electrical performance will be proven as part of the assembly. Examples of this
are described in EN 50393, HD 629 and IEC 60502-1.