This European Standard has been prepared under Mandate M/129 "Space heating appliances" given to CEN
by the European Commission and the European Free Trade Association.
The clauses of this European Standard shown in this annex meet the requirements of the Mandate given
under the EU Construction Products Directive (89/106/CEE).
Compliance with these clauses confers a presumption of fitness of the construction products covered by this
annex for their intended uses indicated herein.
WARNING: Other requirements and other EU Directives, not affecting the fitness for intended use may be
applicable to the construction products falling within the scope of this standard.
Note:
In addition to any specific clauses relating to dangerous substances contained in this European Standard,
there may be other requirements applicable to the products falling within its scope (e.g. transposed European
legislation and national laws, regulations and administrative provisions). In order to meet the provisions of the
EU Construction Products Directive, these requirements need also to be complied with, when and where they
apply. An informative database of European and national provisions on dangerous substances is available at
the Construction web site on EUROPA (CREATE, accessed through http://europa.eu.int)
This annex has the same scope as Clause 1 of this standard. It establishes the conditions for the CE marking
of radiators and convectors intended for the use indicated below and the relevant clauses applicable (see
Table ZA.1).
Construction products: Radiators and convectors
Intended use: heat emitters for central heating systems to be supplied with hot water and steam below 120°C
from a remote heat source (boiler or similar).
The requirement on a certain characteristic is not applicable in those Member States where there are no
regulatory requirements on that characteristic for the intended end use of the product. I (...abbreviated)